IX
162
DRIVING
SPEED LIMITER
System which prevents the vehi-
cle from exceeding the speed pro-
grammed by the driver.
Once the limit speed has been
reached, the accelerator pedal no
longer has any effect.
The speed limiter is switched on
manually: a speed of at least 20 mph
(approximately 30 km/h) must be pro-
grammed.
The speed limiter controls are locat-
ed on the left-hand side of the steer-
ing wheel.
The programmed information is
grouped together in zone A of the
instrument panel screen.
Steering mounted controls
Displays in the instrument
panel
Programming
Rotate the control 1 to the "LIM" po-
sition.
With the engine running, you can
adjust the memorised maximum
speed , by means of short or long
presses on:
) button 4 to increase the memo-
rised maximum speed,
) button 2 to decrease the memo-
rised maximum speed.
Successive presses will modify the
maximum speed in steps of 1 mph
(1 km/h) and a sustained press in
steps of 3 mph (5 km/h).
Activation
When the desired maximum speed
is displayed, press button 3 so that
the limitation is activated.
On selection of the
function, the previous
memorised speed and
the information "OFF"
are displayed in the in-
strument panel.
The information "OFF"
then disappears from
the instrument panel
screen.
While the function is active, press-
ing the accelerator pedal will not en-
able the programmed speed to be
exceeded, except if you press the
pedal hard down to beyond the end-
of-travel switch.
The speed of your vehicle may vary
slightly in relation to that memo-
rised.
The speed limiter cannot, in any circum-
stances, take the place of the obser-
vance of speed limits or of the vigilance
and responsibility of the driver.
To Next Page
Loading...
