III
69
COMFORT
Storing driving positions
System which registers the electrical
settings of the driver's seat and door
mirrors. It enables you to store and
recall two positions using the but-
tons on the side of the driver's seat.
Storing a position
Using buttons M/1/2
) Switch on the ignition.
) Adjust your seat and the door
mirrors.
) Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal indicates that
the position has been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running
) Press button 1 or 2 to recall the
corresponding position.
An audible signal indicates the end
of the adjustment.
You can interrupt the current move-
ment by pressing button M , 1 or 2 or
by using one of the seat controls.
A stored position cannot be recalled
while driving.
Recalling stored positions is deacti-
vated 45 seconds after switching off
the ignition.
To Next Page
Loading...
