Intro 16
Safety Precautions
Labor saving machine Warnings and Precautions
Always read this section before starting use.
CAUTION
Design & Selection
9
Connecting pneumatic brakes
1) The valve for pneumatic brakes is built into the direct drive actuator.
Supply 24 VDC power to external power input across pins 1, 2 and pins 3, 4 of the I/O connector (CN3) for valve power.
2) Supply 0.5 MPa clean compressed air to the brake air joint. Do not supply oil with the lubricator, etc.
3) Built-in brakes for the type with brakes enhance holding rigidity when the output shaft is stopped. Do not use these brakes to brake or stop
a rotating output shaft.
Recommended air circuit for air brakes
Air dryer
Direct drive actuator integrated
Clamp mechanism
Air filter
5μm
Regulator
0.5MPa
SERIAL:
MODEL: AX9000GH
ABSODEX
CKD Corporation
MADE IN JAPAN
MON.
POWER
F1
L1
FG
U
V
W
BK+
BK-
L2
L3
F2
F3
CN2
CN3
CN1
G1
G2
ABSODEX
POWER
3200-230 VAC
50/60HZ
Direct drive actuator
Resolver cable (standard 4m)
(motor cable)
200 VAC three phase
Noise filter
FG
Noise filter for motor cable
If the cable is longer than 6 m,
insert a noise filter on the motor cable.
Driver