3
AX2000G Series
Cable specifications
Cable dimensions
Cable min. bending radius
Resolver
cable
Resolver
cable
50mm 60mm
Standard cable Flexible cable
50mm 60mm
Motor cable
100mm 110mm
Motor cable
100mm 110mm
Resolver cable
Motor cable
(15)
(20)
(22)
(15)
41
(300)
L (standard length 4m)
100
48
18
CE marking
41
100
L (standard length 4m)
450
FG line
(15)
(22)
(20)
(15)
Safety precautions
Use the noise filter for the motor cable if the cable is longer than 6 m.
When connecting the motor cable and driver, check that the cable's mark tubes and driver's indications are correct.
Use the optional flexible cable in applications where the cable is bent repeatedly.
When using a flexible cable, fix the cable sheath near the actuator connector.
When the flexible cable option is selected, flexible cable specifications apply between the driver and actuator connector.
Standard cable specifications apply between the actuator and connector. Fix the cable so that it does not move.
When connecting the cable, firmly insert the connector to the back. Firmly tighten the connector's set screws and fixing
screws.
Do not pull the outlet cable of the device.
Do not modify the cable by cutting or extending it. Failure to observe this could result in faults or malfunction.
To Next Page
Loading...
