EasyManuals Logo
Home>CKD>Dehumidifier>GX8275D

CKD GX8275D User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
12
Transportation
During transport, this product shall not be laid on its
side, and vibration and impact shall not be applied.
Transportation by forklift
Installation & Adjustment
Electric wiring
Use this product within the power voltage range on
specications.
CAUTION
Adjustment and operation
Start/stop the dryer 10 or less times/hour, and after
restarting, wait at least 5 minutes before stopping
again. The stop time must be 3 minutes or longer.
CAUTION
Location
Install this product indoors.
Install an overload protection ground-fault circuit
breaker on the main power supply to provide isolated
overload protection and to prevent electrical shock
from current leakage.
Ground the GND.
CAUTION
Ambient temperature
Do not use this product in a place exceeding the
maximum working temperature.
If maximum working pressure is exceeded, install a
ventilation fan or air inlet, etc.
Do not install the product where it is subjected to
radiated heat.
Do not use this product where the temperature is
lower than the minimum working temperature.
Install the product in a well-ventilated place free of
dirt and dust.
Do not install the product where high levels of
humidity or dew could condense.
Do not install to a splashed location of rain water.
Avoid using the product in direct sunlight or where
heat is generated.
Avoid use in the area containing corrosive gas.
CAUTION
Floor
Install the product on a vibration-free oor.
Provide foundation work if the ground is soft.
Install this product on a at surface.
The anchor bolt position and hole dimensions are
given in the outline drawing.
CAUTION
Vibration
When using a reciprocating compressor, use a
exible tube or high-pressure rubber hose in part of
piping with the air dryer to absorb vibration.
Transportation by crane
WARNING
(Series GX8255D, 8265D, 8275D)
WARNING
Do not start/stop frequently. A failure is caused.
GX Series
Supporting plate
(4 places)
Protect the panel
from damage.
Product
Always extend the claw
Supporting plate
The supporting plate (B) must be
100 mm longer than the dryer
width (A).
Provide protection between
the supporting plate and
dryer to prevent damage to
the panel.
Supporting plate
(4 points)
(A)
(B)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CKD GX8275D and is the answer not in the manual?

CKD GX8275D Specifications

General IconGeneral
BrandCKD
ModelGX8275D
CategoryDehumidifier
LanguageEnglish

Related product manuals