To Next PageTo Next PageWhy does the CKD Dehumidifier “POWER” not turn on?
The "POWER" might not be turning on due to several reasons. First, the power supply itself might not be on, so ensure that it is turned on. Second, the power supply voltage could be abnormal, requiring you to adjust the voltage. A bad harness connection could also be the cause, in which case you should repair the harness. Lastly, the "POWER" lamp itself may be off, indicating it needs replacement.
What to do if CKD Xeroaqua GX dryer does not start when “START” switch is pushed in manual mode?
If the dryer doesn't start when the “START” switch is pushed in manual mode, first, check if the “RUN” lamp is off and replace the ”START” switch. Also, the safety device may be on or bad, so try resetting it. An abnormal power supply voltage can also prevent starting, so adjust the voltage. Ensure the remote stop terminal is short-circuited if it is open. If the “RUN” lamp turns on, replace the electromagnetic switch.
What to do if CKD Dehumidifier dryer does not start when “START” switch is pushed in remote control mode?
If the dryer doesn't start when the “START” switch is pushed in remote control, it could be due to several reasons. Begin by checking if the “RUN” lamp is off, and if so, replace the “REMOTE START” switch. The safety device might be activated or faulty, so attempt to reset it. Ensure that the power supply voltage is normal by adjusting it if necessary. If the remote stop terminal opens, connect an NC switch to it. If the “RUN” lamp turns on, replace the electromagnetic switch.
What to do if CKD Xeroaqua GX suddenly stops?
If the dryer suddenly stops, consider these potential causes: If all the lamps turn off, ensure the power supply is on. If the power supply voltage is abnormal, adjust it. If only the “POWER” lamp is on, remove any unusual causes and reset the unit. This may require lowering the ambient and inlet temperatures, raising the inlet temperature, lowering the treated flow rate, cleaning the dust filter, replacing the fan motor, or replacing the valve for liquid injection. If a remote stop was pushed during manual operation, restart the manual operation. If a manual stop was pushed during remote operation, restart the remote operation.
Why is the pressure drop before/after the CKD Dehumidifier too large?
A large pressure drop before and after the dryer can occur for several reasons. Ensure the stop valve before and after the dryer is fully open. If the screen for the Y-type strainer at the dryer inlet is closed, clean the screen. Make sure the treated flow rate is 1.3 or less times the rated flow. Finally, prevent congelation by raising the ambient and inlet temperatures and ensuring cooling wind does not directly blow on the dryer.
General| Brand | CKD |
|---|---|
| Model | Xeroaqua GX Series |
| Category | Dehumidifier |
| Language | English |
