CKD PPX-R10N-6M-KA - Menu Setting Mode Configuration; Setting Output Modes; Switching Output Type (N.O.;N.C.); Setting Response Time

PPX Series
If the mode switching key is held down long while a setting is made, the RUN mode opens and changed items are set.
Menu setting mode
Standard type
High function type
N.C.N.O.
Output 1: N.C.
Output 2: N.C.
Output 1: N.O.
Output 2: N.C.
Output 1: N.C.
Output 2: N.O.
Output 1: N.O.
Output 2: N.O.
<Setting response time>
5,000ms5ms2.5ms
<Switching main display section display color>
<Switching unit>
(note 2)
Normally greenNormally red
Green when turned ON
Red when turned OFF
Red when turned ON
Green when turned OFF
MPa kPa kgf/cm
2
psi
inchHg (note 3) mmHg (note 3)
bar
RUN MODE
Hold down for 2 secs.
<Setting comparison output 1 output mode>
Window
comparator
mode
Hysteresis
mode
EASY MODE
<Setting comparison output 2 output mode>
(Note 1)
<Switching N.O./N.C>
(Note 1)
Standard type
Window
comparator
mode
Hysteresis
mode
EASY MODEOFF mode
<Analog voltage/current output/external input switching>
<Switching N.O./N.C>
High function type
Remote zero
adjusting input
Analog current
output
Auto
reference
input
Analog voltage
output
RUN MODE
(Note 1): If the comparison output 2 output mode setting is set to "
", the display at N.O./N.C. changeover is the same as the high function
type.
(Note 2): Only "MPa" or "kPa" is available to set for Japan use. Also, setting items for unit switching will not be displayed for low pressure
types.
(Note 3): The high pressure type is not displayed.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
11