<SM-436126-A>
4
1)
Use within ambient temperature of 5～60℃.
2)
Avoid use in the state where inlet air temperature becomes higher than ambient
temperature. (An inside may be covered with waterdrop if the main part of a
super dryer is cooled.)
3)
Keep operating pressure below 1.0MPa.
4)
Avoid installation close to welding or spray painting areas.
5)
Avoid installation in direct sun light.
6)
Air filter of 5μm filtration and oil mist filter to be installed at inlet of Super dryer
when supplied air is lubricated and close to saturated.
7)
Pressure reducing valve, such as regulator to be installed at outlet of Super
dryer.
8)
Super dryers reduce oxygen content. Do not use for breathing air.
CAUTION
CAUTIONCAUTION
CAUTION
To Next Page
Loading...
General