Claas DOMINATOR 204 MEGA III - Component Identification Plates

298 672.0 - BA DO 208 / 204 MEGA 3.3.3
General information
Cutterbar identification plate
The identification plate showing the serial number of
the cutterbar is attached on the right-hand end.
(Fig. 5)
Identification plate of folding cutterbar
The identification plate showing the serial number of
the folding cutterbar is attached on the left-hand side
of the cutterbar back panel.
(Fig. 6)
Maize picker head serial number
The serial number of the maize picker head is
stamped on the picker cross plate behind the
right-hand coupling hole.
The identification plate with the picker number is
attached to the right-hand end of the picker cross
plate.
(Fig. 7)
Multimaster
The identification plate with the picker head number is
attached on the right-hand end of the header's back
plate.
(Fig. 8)
5
6
7
8