Need help?Do you have a question about the Claas LEXION and is the answer not in the manual?
General| Category | Combine Harvester |
|---|---|
| Manufacturer | Claas |
| Engine Power | Up to 790 hp |
| Grain Tank Capacity | Up to 18, 000 liters |
| Threshing System | APS HYBRID SYSTEM |
Purpose and overview of the CLAAS Repair Manual.
Explains manual organization, numbering, symbols, and general instructions.
Defines symbols used in repair procedures for clarity.
Covers important information, safety rules, and danger signs.
Includes cutterbar use, accident prevention, and leaving the machine safely.
Safety for service, basic rules, and handling hydraulic accumulators.
Identifying damage causes, using genuine spare parts, and ordering procedures.
Procedures for chains, taper ring fasteners, self-locking bolts, and locking compounds.
Correct installation of lock collar and adapter sleeve bearings.
Installation and leak correction for ferrule, progressive, and taper fittings.
Safety for welding and general advice for efficient repairs.
Tightening torques for various bolts, screws, and nuts by strength class.
Tightening torques for hydraulic screw fittings with O-ring.
Chart detailing lubricant types and capacities for machine components.
General information on drive belts and chains with diagrams.
Diagram identifying drive chains and belts on the left side.
Diagram identifying drive chains and belts on the right side.
Procedure for removing and installing long/short crop dividers.
Procedure for removing special crop dividers from the cutterbar.
To Next Page
