19
Cab Controls: HOTKEY
The HOTKEY (2) is used to adjust
the more frequently changing
settings on the combine forexample
all the AUTOCONTOURsettings.
To adjust any of the HOTKEY values
turn the rotary switch (2) and the
HOTKEY dial will appear on CEBIS
which is shown in the picture below.
Turn the dial to select the required
icon to make adjustments.
To remove the adjusted settings from
the window, turn the HOTKEY switch
(2) back to the CEBIS (12 o’clock)
position and the previous settings will
be displayed.
After 2 seconds the HOTKEY dial
will disappear from CEBIS and the
settings will be displayed in the
window shown below. To change the
HOTKEY setting value turn switch (4)
either left or right to either increase or
decrease the value.
1
6
7
4
3
2
5
To Next Page
Loading...
