37
Settings: Straw and Chaff Management
TIP. Make sure the chopper blades are kept in good condition and worn or
damaged ones are either turned or replaced.
TIP. Back off the stationary knives until the desired chop length is met.
TIP. On machines equipped with Special Cut II choppers make sure that
the fine chop step is only used when necessary.
The chaff spreader can be adjusted to spread chaff wider. See operator’s
manual for adjustments.
The straw chopper can be engaged
and disengaged from work by operating
the buttons on the rear of the machine
or via CEBIS. The chopper cannot be
moved if the chopper is rotating. Turn
switch up or down this will move the
spreader into the first position if it needs
to be moved further, release the switch
and turn it again.
When using the chopper do justenough.
TIP. Make sure the hood has stopped
moving before releasing the switch.
To Next Page
Loading...
