VENTING THE AIR FROM THE CIRCUIT
FOR YOUR OASIS TO OPERATE CORRECTLY, YOU MUST EXPEL ALL THE
AIR FROM INSIDE THE CIRCUIT. THE PROCEDURE IS VERY SIMPLE:
•
A SET UP THE SYSTEM AND SWITCH ON
YOUR OASIS WITH YOUR PREFERRED
PROGRAM.
•
B DISCONNECT THE HOSE CONNECTED TO ANY OF THE DRIPPERS,
PUT YOUR FINGER OVER ONE END TO SEAL IT, AND WAIT FOR WATER
TO FLOW FROM THE FREE END.
• C NOW PUT A FINGER OVER THE END OF THE HOSE FROM WHICH WATER
IS FLOWING, AND AT THE SAME TIME REMOVE YOUR FINGER FROM THE
OTHER END OF THE LOOP, SO THAT WATER FLOWS FROM THERE THIS TIME.
• D YOU CAN NOW RECONNECT THE HOSE
TO THE DRIPPER, RESTORING THE LOOP
CIRCUIT. YOUR OASIS IS NOW READY TO
GIVE YOU TROUBLEFREE SERVICE.
A
B2
C1
C2
B1
D
UK
23
02_OASIS_UK_misure inglesi 10-06-2009 16:21 Pagina 23
To Next Page
Loading...
