• IT IS NOW TIME TO FIT THE
DRIPPERS.
CUT THE HOSE CLOSE TO EACH
STAKE - LET'S SAY ABOUT 2 CM
(0.8 IN) AWAY - AND CONNECT
A
DRIPPER BY PRESSING THE HOSE
FIRMLY ONTO EACH END
(SEE PHOTO 7). IT IS BEST TO
FIT THE DRIPPER SO THAT
THE OUTLET NOZZLE IN THE
CENTRE IS FACING
DOWNWARD
(SEE PHOTO 8).
• THE DRIPPER IS NOW CLOSE
TO THE STEM OF THE PLANT
AND IS SUPPORTED BY THE
HOSE, SUPPORTED IN ITS TURN
BY THE STAKE.
• USE THE SAME PROCEDURE
FOR ALL THE OTHER STAKES,
UNTIL ALL THE DRIPPERS
REQUIRED HAVE BEEN FITTED.
YOU HAVE NOW CREATED
THE CIRCUIT WHICH WILL
DISTRIBUTE THE WATER TO
THE POTS, COMPLETE WITH
DRIPPERS. IT CAN ALSO BE RE-
USED ON LATER OCCASIONS
IF THE TANK AND POTS ARE
ARRANGED IN THE SAME WAY.
THE DRIPPERS CAN ALSO BE
CLEANED AND INSPECTED TO
ALLOW THEM TO BE CLEANED
INSIDE IF NECESSARY: TO DO
THIS, SEPARATE THE TWO
PIECES WHICH MAKE UP THE
DRIPPER AND RINSE THEM
UNDER RUNNING WATER.
UK
18
6
7
8
To Next Page
Loading...
