F I L T E R A G + S e r i e s F i l t e r
Installation Operation Maintenance Manual
FILTERAG+ WS Rev 1 Page 3 of 16
1 UNPACKING AND PARTS LIST
1 . 1 U N P A C K I N G N O T E S
The unpacking of the Filter is quite straightforward, and there are no ‘hidden’
items. It is advisable to keep the packages sealed until such time as they are
used, to prevent dust or water entry.
1 . 2 B A S I C P A R T S L I S T
1. VALVE (c/w flow controllers on outlet and drain)
2. CLACK MANUAL
3. INSTRUCTIONS
4. VESSEL (c/w riser and distribution system)
5. 4” - 2 1/2” REDUCER (if required)
6. FILTER AG + (qty as specified)
1 . 3 M I S S I N G O R D A M A G E D G O O D S
Immediately on receipt of the goods, it is advisable to check that all items
ordered have been received. If you have any doubt that goods have been
supplied as requested, please contact your supplier immediately. If any items
are missing or damaged, the carrier and your supplier must be notified within 2
days of receipt if a claim is to be made.
2 TEMPORARY STORAGE
If installation is not to start immediately after delivery, the equipment should
be stored in a clean dry area, where it will not be damaged, or be subjected
to temperatures below freezing.
3.0 GENERAL NOTES
These instructions cover the FILTER AG + Range of filters, which includes model
numbers from CAP1054 to CAP 2469.
It is recommended that these instructions are read thoroughly before commencing
any work on the unit, particularly if you have no previous experience of installing and
using a filter.
3 . 1 T u r b i d i t y R e m o v a l
Turbidity in the water is removed by filtration as the water passes through the bed. A
support bed of gravel is used to protect the distributer and 2 grades of sand and
anthracite to remove decreasingly smaller particles as the water passes through the