CLAGE
9
EN
Problem Cause Solution
Water stays cold,
display does not light
up
Master fuse tripped Renew or activate fuse
Safety pressure cut-out
tripped
Contact customer service
Water stays cold,
display does light up
Safety thermal cut-out
tripped
Contact customer service
Flow rate of hot water
too weak
Outlet fitting dirty or
calcified
Clean shower head, jet
regulator or sieves
Fine filter dirty or calcified Clean fine filter
Selected temperature
is not reached
Excessive water flow
(winter?)
Reduce water flow rate at the
outlet
4. Trouble-shooting and service
Repairs must only be carried out by
authorised professionals.
If a fault in your appliance cannot be
rectified with the aid of this table,
please contact the service organisa-
tion of your importer or the Central
Customer Service Department. Please
have the details of the typeplate at
hand.
This instantaneous water heater was manufactured conscientiously and checked sever-
al times before delivery. Should malfunctions nevertheless occur, it is usually only due
to a bagatelle. First attempt to switch the house fuses off and on again in order to reset
the electronics. Next, try to remedy the problem with reference to the following table.
In doing so, you will avoid unnecessary expense of customer service assistance.
CLAGE GmbH
After-Sales Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Phone: +49 4131 8901-40
Fax: +49 4131 8901-41
Email: service@clage.de
To Next Page
Loading...
Need help?
General
