clage DX 21 User Manual

Durchlauferhitzer DX 18..27 Instantaneous water heater
Montage- und Gebrauchsanleitung
Installation and operating instructions
Die Montage (Wasser- und Elektroinstallation), erste Inbetriebnahme
sowie die Wartung dieses Gerätes dürfen nur durch einen zugelassenen Fachmann
entsprechend dieser Anleitung vorgenommen werden!
Mounting (water and electrical installation), initial operation and maintenance
of this appliance must only be conducted by an authorised professional
according to these instructions!
D
GB

clage DX 21 Specifications

General

Type	Instantaneous water heater
Rated Power	21 kW
Voltage	400 V
Frequency	50/60 Hz
Protection Class	IP 25
Activation Flow Rate	2.5 l/min
Temperature Range	30 - 60 °C
Control Type	Electronic
Specific Water Delivery at dt 30K	11 l/min
Water Connection	G ½"
Phase	3
Maximum Flow Rate	11 l/min

Summary

Overview

General Safety Instructions

Technical Specifications

Installation

Installation Site Requirements

Mounting the Wall Holder

Step-by-step instructions for mounting the wall holder for the appliance.

Installing Water Connections

Mounting the Appliance Unit

Steps for physically mounting the appliance onto the wall holder.

Direct Connection Plumbing

Electrical Connection by Specialist

Standard Electrical Connection (Bottom)

Detailed steps for electrical connection from the bottom of the unit.

Electrical Connection from Above

Detailed steps for electrical connection from the top of the unit.

Initial Commissioning and Startup

Operating the Appliance

Setting the Desired Temperature

How to adjust the water temperature using the control panel buttons.

Using Program Keys

Temperature Limiting Features

Custom Temperature Limiting

Venting After Maintenance

Maintenance Procedures

Filter Strainer Cleaning & Replacement

Troubleshooting and Customer Service

Warranty Terms and Conditions