Need help?Do you have a question about the Clarion 2/1 Channel Power Amplifier DPX1000.2 and is the answer not in the manual?
General| Power Output (RMS) | 1000W |
|---|---|
| Crossover Type | Variable Low-Pass/High-Pass |
| Fuse Rating | 30A x 2 |
| Input Sensitivity | 0.2V - 6V |
| Crossover Frequency (Low-Pass) | 50Hz - 250Hz |
Instructions on reading the manual and warranty information, including filling out the card and saving the receipt.
Connections for high-level stereo sources or when RCA outputs are unavailable.
Gold-plated RCA jacks for audio input, labeled RIGHT and LEFT.
Port for the supplied remote gain control for adjusting amplifier gain remotely.
Sets the nominal operating level of the amplifier, accepting various input levels.
Activates the Subsonic Filter Circuit to eliminate frequencies below 24Hz.
Features a 'high-Q' circuit with adjustable gain for low-frequency audio response tuning.
Fully adjustable crossover frequency selection between 55Hz and 550Hz.
Changes the X-Over slope between 12dB and 24dB per octave.
Changes the output between lowpass and fullrange modes.
Sets the input mode: Stereo, Bridged (Right In), or Sum Mono.
Connection for the left speaker output.
Connection for the right speaker output.
Connection for the amplifier's ground wire.
Connection for the remote turn-on signal from the source unit.
Connection for the main positive power supply from the battery.
Precautions for mounting the amplifier safely and effectively for cooling and access.
Safeguards for proper and safe wiring connections, including power and ground.
To Next Page
