Basic Operations
English
10 CX501E
● Adjusting the subwoofer output
volume
You can adjust the volume output from the unit’s
subwoofer output terminal.
This adjustment can be performed only when
the “REAR/S-W” is set to “S-WOOFER”
(page 22).
2-1. Select “S-W VOL”.
3-1. Turn the [ROTARY] knob to increase or
decrease the subwoofer volume.
∗ The factory default setting is “0”.
(Adjustment range: +6 to –6)
● Setting the PHASE
This set can be performed only when the
“REAR/S-W” is set to “S-WOOFER” (page 22).
2-1. Select “PHASE”.
3-1. Turn the [ROTARY] knob to select as
following order:
“NORMAL” ↔ “REVERSE”
∗ The factory default setting is “NORMAL”.
● Adjusting the HPF
2-1. Select “HPF”.
3-1. Turn the [ROTARY] knob to select as
following order:
“THROUGH” ↔ “60” ↔ “90” ↔ “120”
∗ The factory default setting is “THROUGH”.
Note:
• During SOUND adjustment mode, if no operation
is performed for more than 10 seconds, this
mode can be cancelled and return to previous
mode.
CT (Clock Time) function
The CT function receives CT data sent from an
“Radio Data System” station and displays the
time.
∗ If a CT data is not being received, “CT– –:– –”
appears in the display.
Note:
• CT data is not transmitted in some countries and
by some broadcast stations. Also, in some areas,
the CT may not display accurately.
CX501E_EN.book Page 10 Thursday, November 11, 2010 1:16 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
