Ins talla tion
H Screwing the Faceplate on the Unii
If ypu want to fasten the faceplate to the main
unit so that it does not fall off, screw in the pro-
vided screws
(04
X 16 mm) in the holes shown
below.
Accessory @
Never insert the taptite screw (04 x 16 mm) in
any other screw hole than the one specified. If
you screw it in another hole, it will contact and
may cause damage to the mechanical parts in-
side the unit.
W Removing the hard rubber frame
1. Engage the catch pins on the removal tool and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown
in the figure.
Accessory @ Removal tool
2. When the lower level is removed, remove the
upper two locations.
Note:
l
The frame can be removed from the top side in
the same manner.
n Removing the Unit
1, Refer to the section “Removing the hard rub-
ber frame” and then remove the hard rubber
frame.
2. Remove the screw (M4x8) on the back panel.
3. Insert the two removal tools deeply into the
slots on each side, as shown.
Screw (M4x8)
(commercially available)
Accessory @ Removal tool
4. Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Note:
l
Be careful to avoid injury from the catch pins on
the removal tool.
5. Pull the unit all the way out with your hands,
being careful not to drop it.
DB625MP
23
Installation
• Screwing the Faceplate on the Unit
If
you want
to
fasten the faceplate
to
the main
unit so that it does not fall off, screw
in
the pro-
vided screws (04 X 16 mm)
in
the holes shown
below.
Accessory
®
• Removing the Unit
1.
Refer to the section "Removing the hard rub-
ber frame" and then remove the hard rubber
frame.
2.
Remove the screw (M4x8) on the back panel.
3.
Insert the two removal tools deeply into the
slots
on
each side, as shown.
Accessory
® Removal tool
Screw (M4x8)
(commercially available)
~
4.
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Note:
• Be careful
to
avoid injury from the catch pins on
the removal tool.
5.
Pull the unit all the way out with your hands,
being careful not
to
drop
it.
Catch
.~
Lock
------.
~
~J(,~t1
:>
Accessory ® Removal tool
~!
~
• Removing the hard rubber frame
1.
Engage the catch pins
on
the removal tool and
remove the two locks
on
the lower level.
Lower the frame and pull it forward as shown
in
the figure.
Never insert the taptite screw (04 x 16 mm)
in
any other screw hole than the one specified. If
you screw it
in
another hole, it will contact and
may cause damage
to
the mechanical parts in-
side the unit.
2.
When the lower level
is
removed, remove the
upper two locations.
Note:
•
The
frame can be removed from the top side
in
the same manner.
DB625MP
23
To Next Page
Loading...
