18
English
DXZ368RMP
RDS Operations
• Cancelling the TA standby mode
As “TP” and “TA” lit in the display, press the
[
TA
]
button. The “TA” in the display goes off and the
TA standby mode is cancelled.
∗ If “TP” is not lit, pressing the
[
TA
]
button searches
for a TP station.
• Searching for a TP station
When “TP” is not lit, if you press the
[
TA
]
button,
“TA” in the display lights and the unit automatically
receives a TP station.
Note:
• If a TP station is not received, the unit continues
the search operation. Pressing
[
TA
]
button again
goes off “TA” in the display and stops TP station
searching.
Auto store function for TP stations
You can automatically store up to 6 TP stations
into preset memory. If the number of TP can be
received less than 6, broadcast stations already
stored in memory and left without being overwrit-
ten.
As “TA” lit in the display, press and hold the
[
]
button for 2 seconds or longer. The TP stations
with the good reception sensitivity are stored into
preset memory.
∗ Even if you select FM1 or FM2, a TP station is
stored into memory for FM3.
RDS MODE adjustment
Press and hold the
[
ADJ
]
button for 1 second or
longer to select the RDS MODE.
The mode switches as follows each time the
[ , ]
lever are pressed upward or downward:
PTY ON PTY-S<E> AF ON REG
ON
∗
INFO SEL
(
E
)
....
Press
[
ADJ
]
button to exit RDS MODE.
∗
“REG ON” only available when “AF ON”.
PTY
This function enables you to listen to a broadcast
of the selected programme type even if the unit is
on a function mode other than radio.
∗ Some countries do not yet have PTY broadcast.
∗ In the TA standby mode, a TP station has priority
over a PTY broadcast station.
∗ The factory default setting is “OFF”.
1. Press and hold the
[
ADJ
]
button for 1 second
or longer to switch to the RDS adjustment
selection display.
2. Press the
[
,
]
lever upward or downward
to select “
PTY”.
3. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
• ON:
“PTY” in the display lights and PTY standby mode is
turned on. When the selected PTY broadcast starts,
the PTY item name appears in the display.
• OFF:
“PTY” in the display goes off and PTY standby mode
is cancelled.
4. Press the
[
ADJ
]
button to return to the previous
mode.
• Cancelling a PTY interrupt broadcast
Press the
[
TA
]
button during the PTY interrupt
broadcast, the PTY interrupt is cancelled and the
unit returns to PTY standby mode.
Selecting PTY
1. Press and hold the
[
ADJ
]
button for 1 second
or longer to switch to the RDS adjustment
mode.
2. Press the
[
,
]
lever upward or downward
to select “PTY-SEL <E>”.
3. Press the
[
]
button.
4. Press any one of the
[
DIRECT
]
buttons to call
the Preset Memory for PTY selection..
Alternatively, turn the
[
ROTARY
]
knob to select
the desired PTY.
5. Press the
[
ADJ
]
button to return to the previous
mode.
∗ Below are the factory default settings stored for
the
[
DIRECT
]
buttons.
To Next Page
Loading...
