Clarion FZ105BT - 5 Operations; Basic Operation; System Menu; Audio Menu

FZ105BT 5
5. OPERATIONS
Basic Operation
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level it may cause hearing
damage. Be careful about adjusting the
volume.
Power On/Off
Engine ON
position
Note: Be sure to read this chapter referring
the chapter “4.CONTROLS”
to
Note:
Start the engine before using this unit.
Be careful about using this unit for a long
time without running the engine. If you drain
the vehicle battery too far, you may not be
able to start the engine and this can reduce
the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
2. Press the [ / MUTE ] button to turn the
power On or Off .
Adjusting the volume
1. Rotating the [VOLUME] to increase/decrease
the volume.
The adjustable range of volume is 0 to 46.
Mute
Display System information
Press the [MUTE] button to turn the mute On
and Off.
Press the [INFO] button on the front panel to
switch the display information, system time and
playing source.
System Menu
CLOCK
12/24H
DX / LO (radio mode)
In any mode, press [ MENU ] button to enter
System Menu. Press [ ] or [ ] button
to select options, rotate the [ VOLUME ] knob
to adjust a value / option.
Rotate the [VOLUME] knob to choose radio
Local or distant at RADIO mode.
LO: Only stations with strong signal can be
received.
DX: Stations with strong and weak signals
can be received.
BEEP ON/OFF
Rotate the [VOLUME] knob to choose button
Beep sound On or Off.
Rotate the [ VOLUME ] knob to choose time
format: 12 or 24 hours.
DIMMER
TUNE AREA (radio mode)
Rotate the [VOLUME] knob to select suitable
country region:
U.S.A (United States)
LATIN (Latin America)
EUROPE (Eastern/Western Europe)
ASIA (Asia Pacific)
DIS-CON / RE-CON
Disconnect / Re-connect currently connected
mobile phone.
Press the [MUTE] button to disconnect /
Rotate the [VOLUME] knob to adjust the default
volume.
DEFAULT VOL
Re-connect.
Press [ ] button to enter sound effect setting
mode. Press [ ] or [ ] button to select
options, rotate the [ VOLUME ] knob to adjust
a value / option.
EQ (Preset Equalizer Setting)
Rotate the [VOLUME] knob to change EQ:
Flat->Jazz->Pop->Classic->Rock->News->
Urban->Rave->Movie->Techno->User
Audio Menu
English
Selecting a mode
1. Press the [SOURCE] button to display
menu.source
*
External equipment not connected to this
unit is not displayed.
When the [EQ USER] is appear, press the
[MUTE] button to enter into below option and
rotate the [VOLUME] knob to adjust a value:
BASS(bass): range -7 to +7
MID(middle): range -7 to +7
TREB (treble): range -7 to +7
Rotate the [VOLUME] knob to set clock, rotate
the [VOLUME] clockwise to adjust the minutes
and counterclockwise to adjust the hours.
Rotate the [ VOLUME ] knob to adjust the LCD
display backlight level between High or Low.
BAL (Balance)
Rotate the [VOLUME] knob to adjust the
balance between the right and left speakers
from 01 R (full right) to 10L (full left).
FAD (Fader)
Rotate the [VOLUME] knob to adjust the f ader
between the front and rear speakers from
10R (full rear) to 10F (full front).
SUB LPF (SUB ON)
Rotate [VOLUME] knob to adjust the subwoofer
Low Pass Filter range: 80HZ/120HZ/160HZ
SUB GAIN (SUB ON)
Rotate the [VOLUME] knob to adjust the
subwoofer gain range: 0 to 12
XBS On/Off
Rotate the [VOLUME] knob to turn On or Off
the X-BASS bosster function.
SUB On/Off
Rotate the [VOLUME] knob to select subwoofer
between ON and OFF