Installing the Main
Unit
in
a TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked *are attached to the vehicle.)
Center Panel
(* 2)
Figure 7
'------
Mounting bracket
(1
pair for the left
and right sides)
Note:
*2:
Some panel openings are too small for the unit
depending on the vehicle type
and
model.
In
such a case, trim the upper
and
lower sides
of
the
panel frame
by
about 0.5
to
1.5 mm so the unit
can be inserted smoothly.
*3:
If
a hook on the installation bracket interferes
with the unit,
bend
and
flatten
it
with a nipper
or
similar tool.
Typical Mounting Brackets
Example 1
....
1-
ur--
.........
_
.....
Example 2
Example 3
Affix the screws
to
the.
marks.
Vehicles
other
than NISSAN
and
TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
• Removing
the
Main
Unit
When the main unit is to be removed, disassemble it
in
the reverse of the order in "INSTALLING THE
MAIN UNIT'
(see page 48).
41
VRX485VD/MAX385VD
To Next Page
Loading...
