- 16 -
QX-3870N-A
1 Remove the 2 FFC connector locks of HDVD mechanism (A). A 1
Refer to method for DVD handling.
The spring should not be extended.
2B1
3C1
4D1
E3
Tightening torque: 0.4 N·m
Tightening sequence is specified. (1) to (3)
5F1
G 2 Tightening torque: 0.4 N·m
Tightening sequence is specified. (1) to (2)
[Method for handling the DVD (2)]
(1)
Insert the contact points on one side of FFC-50PIN-169MM (B)
into the connector of the HDVD mechanism and lock it.
* Pass the 2 FFCs through the ☆ holes of
mechanism BRKT-B (F).
Electric screwdriver (0.4±0.04 N·m)
Fit the 2 half pieces of mechanism BRKT-B (F) securely in the
2 positioning holes of the HDVD-MC mechanism and tighten
them with 2.6 x 4 screws (G).
Insert the contact points on one side of FFC-18PIN-248MM (C)
into the connector of the HDVD mechanism and lock it.
Tools to be used
Assembly 3
QX-3870N-A
(NAU-3225KCA-C)
04
Part No.
Work processing drawing Important control items
No.
[Method for handling the
DVD (1)]
Fit the half piece of mechanism BRKT-A (D) securely in the
positioning hole of the HDVD mechanism and tighten it with
2.6 x 4 screw (E).
Work procedures
Qty
EKZ0192
929-2131-88
MJZ0661
* Do not touch the board of the mechanism rear
surface or the motor lead wire of the mechanical
part of the mechanism.
MJZ0661
Do not touch the board of the mechanism rear
surface or the motor lead wire of the mechanical
part of the mechanism.
Insert the FFC to its base and check that it is
securely locked.
Do not press the FFC excessively so that contac
points bend over.
Insert the FFC to its base and check that it is
securely locked.
Do not press the FFC excessively so that contact
points bend over.
Before installing mechanism BRKT (A), check that
wire termination has been performed for the FFC
(18P) as shown in the figure.
EKZ0143
NAZ7644
NAZ7652
The spring should not be
extended.
OK sample
NG sample
A
Mark dots in 2 places.
C
B
D
(A)
E
(1)
(2)
(3)
F
G
(1)
(2)
Motor lead
Remove the 2 FFC
connector locks.
Half pierce
Pass the 2 FFCs though this hole.
Mechanism drive structure
FFC
E
To Next Page
Loading...
