- 17 -
QX-3870N-A
(Fig. 1)
1
ffix TAPE-DV5 (B) to HDVD mechanism (A).
A(1)
(Refer to Fig. 1.)
B1
2
C1
3
4
D2
Tightening torque: 0.4 N·m
Tightening sequence is specified. (1) to (2)
(Fig. 2) [Method for handling the DVD]
(1)
MJZ0532
.8829007A
--------
MUZ2285
Important control items
Qty
Work processing drawing
Tools to be used
Electric screwdriver (0.4±0.04 N·m)
Part No.
Work procedures
No.
Assembly 4
QX-3870N-A
(NAU-3225KCA-C)
05
Remove the connector cap and FFC connector lock of
M/C-PWB (C).
Insert the FFC (large) from the HDVD mechanism into the
M/C-PWB connector and lock it.
Install the M/C-PWB on the HDVD mechanism and tighten it
with 2.6 x 8 screws (D).
* Do not touch the board of the mechanism rear
surface or the motor lead wire of the mechanical
part of the mechanism.
Insert the FFC to its base and check that it is
securely locked.
Refer to Fig. 2 for the FFC termination when
installing the M/C-PWB.
Affix it so that it covers the fixing tab of mechanism
BRKT (A) and mechanism BRKTs (A) and (B).
A
B
(B)
(A)
C
Remove the
connector cap.
(1)
(2)
D
[Reference images]
Motor lead
FFC
Remove the FFC
connector lock.
Mechanism drive structure
To Next Page
Loading...
