EasyManua.ls Logo

Clarion Ungo Pro Security K10 - Override Mode; Panic Mode

Clarion Ungo Pro Security K10
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
override mode
You can prevent your system from automatically activating the Starter Kill
and locking the doors by using override mode. This is very useful when
washing the vehicle or having it serviced. In override mode, the starter kill
cannot be activated, even with the remote, but all convenience functions
(door locks, trunk release, etc.) will continue to work normally.
To enter or exit override mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and then release the
Override switch within 10 seconds.
The status LED will light steadily if you are entering override mode and
will turn off if you are exiting override mode.
panic mode
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your remote. Just press for two sec-
onds to enter panic mode. In panic mode, the horn will honk and the
parking lights will flash for 30 seconds. To stop panic mode at any time,
press on the remote again.
nnoottee::
In order for panic mode to be effective, the vehicle’s
horn (or optional siren) as well as the vehicle's parking lights
must be connected.
DRW-35

Related product manuals