11
programming options
Programming options control your system's normal, operational set-up.
Most options do not require additional parts, but some may require
additional installation labor. This system's programming options are list-
ed below, with the factory default settings in bold:
z
Passive Mode or Active Mode. In Passive Mode the Starter
Kill will automatically activate 30 seconds after the ignition
has been turned off.
z
Ignition switch-controlled door-locking on or off. With this
feature on, the doors will lock 3 seconds after the ignition
key is turned on, and unlock when the ignition key is turned
off.
z
Passive Locking or Active Locking (doors lock only with the
remote). With Passive Locking, the vehicle doors lock auto-
matically 30 seconds after the ignition has been turned off.
Passive Locking can only be selected when the system has
been programmed for Passive Mode.
z
The horn honk confirmations for locking and unlocking can
be programmed on or off. In order for this feature to work
properly, the horn must be connected to the system.
z
Domelight supervision when the key is turned off can be
programmed on or off. If programmed on, the domelight
will turn on for 30 seconds each time the ignition is turned
off.
To Next Page
Loading...