5.11
If the
forks are longer than the load, move the tips partially under the
load without extending beyond the load. Raise the load to clear the
oor. Back out several inches, or whatever distance is necessary, then
set the load down and move forward until the load is positioned against
the face of the forks.
Then raise the load to traveling height.
Unloading
To deposit a load after being moved into the correct position, lower the
load to the oor.
Adjust the fork height as necessary, for smooth removal of the forks
from the load (pallet).
Carefully withdraw the forks from the load.
Raise the forks to traveling height.
Operating Procedures
To Next Page
Loading...
