SPECIFICATIONS
Motor Voltage: ................................................................ 230V, 50Hz, 1 phase.
Rating: .................................................................. 90 Watts
Maximum thickness of cut: ......................................................... 50mm (2")
Throat: ............................................................................................ 400mm (16")
Blade length: ................................................................................. 125mm (5")
Strokes per minute: ...................................................................... 1400
Stroke length: ................................................................................ 20mm (3/4")
Table size: ...................................................................................... 375 x 200mm
Machine dimensions: ................................................................... 540x265x360mm
Table tilt: ........................................................................................ 0
O
- 45
O
left
Base size: ....................................................................................... 400 x 215mm
Blade Type: ................................................................................... Pin (plain type optional)
Gross / Net weight: ....................................................................... 22 / 20kg
Please note that the details and specifications contained herein, are correct at the time of going to print. However,
CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the
machine’s data plate
For Spare Parts and Service,please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
PARTS & SERVICE CONTACTS
15
To Previous Page
Loading...
