What causes condensation in crank case of Clarke SE16C150 Air Compressor?
Condensation in the crankcase of your Clarke Air Compressor, especially in 2-stage compressors, can be caused by the compressor being over-dimensioned. This means operational periods are too short relative to resting periods. Try frequent oil changes and reduce cooling of crankcase.
Why is my Clarke SE16C150 electric motor too hot?
If your Clarke Air Compressor's electric motor is too hot, ensure that the operational voltage is not too low (call an electrician) and that the cooling fins of the electric motor are not blocked by dirt (clean the cooling fins).
What causes condensation at outlet points of Clarke SE16C150 Air Compressor?
Condensation at the outlet points of your Clarke Air Compressor can be caused by: * Incorrect piping installation: Consult your local dealer. * Compressor taking in air that is too warm: Obtain a better fresh air supply for the compressor. * Delivery temperature of air from air receiver is too high: Use a larger air receiver.
Why bleed valve under pressure switch blows whilst Clarke SE16C150 Air Compressor is running?
If the bleed valve under the pressure switch blows while your Clarke Air Compressor is running, it could be due to a leaking relief valve. Clean the relief valve or change the pressure switch.
Why bleed valve under pressure switch blows whilst Clarke SE16C150 Air Compressor is not running?
If the bleed valve under the pressure switch blows while your Clarke Air Compressor is not running, it is likely due to a leaking non-return valve. Clean or replace the non-return valve.
Why Machine running but not pumping air into the receiver (10HP only) Clarke Air Compressor?
If the machine is running but not pumping air into the receiver (10HP only), and air is exhausting from the solenoid after the starter has changed direction from star to delta, check the solenoid valve.
Table listing specifications for various CLARKE air compressor models.
Instructions for adjusting outlet pressure on portable compressor models.
Notes that stationary models do not have adjustable outlet pressure.
Details how to reset the motor overload protector on single-phase models.
General| Brand | Clarke |
|---|---|
| Model | SE16C150 |
| Category | Air Compressor |
| Language | English |
To Next Page
