Clas Ohlson BT-202 - Battery Operation; Setting the Clock

5
English
Operating instructions
Battery operation
Note: Never mix old and new batteries and never mix rechargeable batteries with non-rechargeable
batteries.
1. Remove thebattery cover (13) on theback of theradio.
2. Lay thebattery removal ribbon on thebottom of thebattery holder.
3. Insert 4×AA/LR6 batteries (sold separately). Note thepolarity markings on thebottom of
thebattery holder to ensure correct insertion.
4. Refit thebattery cover.
5. Thedisplay turns off afew seconds after theradio is switched on in order to save battery power.
Mains adaptor operation
1. Connect theadaptor to theadaptor socket (11) and to anavailable power point.
2. Thedisplay will stay on for as long as theradio is powered by themains adaptor and is
switched on.
On/off
1. Press [ SOURCE ] once, theradio enters theplayback mode it was in when it was last
switched off.
2. Select theplayback mode by pressing the [
SOURCE ] button repeatedly in quick
succession.
3. Hold in [
SOURCE ] for 2 seconds to turn the power off.
Setting theclock
With theradio turned off, hold in [ SET/MEM/M+ ] until “24” flashes on thedisplay.
Press [ ] or [ ] to select 12- or 24-hour clock mode.
1. Press [
SET/MEM/M+ ] again, thehours will flash. Press or hold in [ ] or [ ] to set
thehours.
2. Press [
SET/MEM/M+ ] again, theminutes will flash. Press or hold in [ ] or [ ] to set
theminutes.
3. Press [
SET/MEM/M+ ] again to exit thesettings mode.
FM radio
1. Fully extend theFM aerial (10).
2. Switch theradio on and press [
SOURCE ] again to select FM radio as theplayback
source. “FM” appears on thedisplay.
3. Press [
] or [ ] repeatedly in quick succession to select theradio frequency. You can also
hold in one of thebuttons until theradio starts to scan for thenearest radio station up or
down thefrequency band. Release thebutton once theradio has begun to scan.
4. When theradio has found astation and you wish to change to another station, you can hold
in one of thebuttons again to search again.
5. Set thedesired volume using [
] or [ ].
6. Change theangle of theaerial or move theradio if thereception is poor.