Clas Ohlson BT-202 - Troubleshooting Guide

8
English
Troubleshooting guide
Theradio will not
switch on.
• Check thebatteries and change them if necessary.
• Make sure that themains adaptor and lead are intact and properly
connected to both theelectrical socket and theradio.
• Is there power at thewall socket being used?
Poor or non-existent
radio reception.
• Make sure that theaerial is fully extended.
• Try changing theangle of theaerial.
• Move theradio to another location.
No sound from
theconnected
device.
• Check thevolume level on both theradio and theconnected device.
If using theAUX-IN:
• Check that thecable connecting thedevice and theradio is
undamaged and properly connected.
• Is theradio in AUX-IN mode?
If using Bluetooth:
• Make sure that theBluetooth connection is correct.
• Test theplayback from your external device before connecting it.
• Try playback using another file. Thefile you are attempting to play
may be damaged.
• Pull theplug from thewall socket to disconnect theBluetooth radio
completely from themains. Insert theplug back into thewall socket.
Things to consider:
• Other wireless equipment using thesame frequency band can reduce
thetransmission range.
• Therange of all wireless equipment depends on thetype of
obstacles located between thetransmitter and thereceiver
(e.g. aconcrete wall will interfere with thesignal more than
aplasterboard wall).
If you experience problems, try thefollowing:
• Turn off any other existing wireless equipment to check whether
this is thecause of theproblem. Reposition thewireless equipment,
shorten thedistance between thetransmitter and thereceiver or
reduce thenumber of obstacles (walls, furniture, etc.) between
them.
If none of theabove
works, try resetting
theradio to its
default factory
settings.
• Remove thebatteries and unplug themains adaptor. Wait for at least
5 minutes. Refit thebatteries and reconnect themains adaptor.
Turn theradio on again.