SECTION 6: MAINTENANCE
E-9
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs
or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately
call a qualified service technician to inspect the fireplace and replace any part of the
electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce
the risk of fire, electrical shock or personal injury.
The motors used on the fan and the flame gen-
erator assembly are pre-lubricated for extended
bearing life and require no further lubrication.
However, periodic cleaning/vacuuming of the
fan/heater unit is recommended. The louvers/vent
in the control door should be cleaned periodically,
both inside and out. When the control door is in
the open position the heater grill/screen should be
vacuumed. The area around the controls should
also be kept clean. Make sure the unit is turned
OFF and unplugged whenever you are cleaning
the heater or fireplace.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding
and securing locations must be followed.
To Next Page
Loading...
