[
H
]
[
G
]
9
4. Once holes are drilled, remove tape and
mounting template and save template
with your instructions in case you move
or wish to remount at a later time.
5. Wipe dust and debris o inside cabinet
surface. Also, make sure under side of
cabinet is clean.
6. Place a washer inside the cabinet over each of the 4 holes you drilled.
7. Now, use your ruler or the paper ruler provided to measure the overhang height, placing
your ruler vertically against the underside of the cabinet behind the overhang
[
G
]
. If this
measurement is less than 1-3/4”, you may skip step 9. If it is greater than 1-3/4”, this number
determines the number of spacers you need, using the SPACER MOUNTING GUIDE
found below.
8. Drop one of your screws through each
of the washers covering the holes in the
cabinet, from inside the cabinet down.
9. Place the appropriate number of spacers
determined in step 7 on each screw
so the appliance will be even with the
front overhang
[
H
]
.
NOTE: For spacer installation, you may require assistance (in mounting) in order to hold
spacers in place while securing the appliance at the same time. If assistance is not avail-
able, use pieces of tape to hold the spacers in place while you position the appliance.
SPACER MOUNTING GUIDE
MEASUREMENT SPACER
1-3/4” or less None
1-13/16” 1/16”
1-15/16” 3/16”
MEASUREMENT SPACER
2” 1/4”
2-1/16” 1/4” + 1/16”
2-3/16” 1/4” + 3/16”
To Next Page
Loading...