[B] [
C
]
6
GETTING STARTED
1. Remove all packing material.
2. Remove and save literature.
3. Unpack mounting washers, screws and spacers for mounting and set them aside in a safe
place where they will not roll away or get lost.
IMPORTANT: Do not attempt to operate appliance until it is properly installed. This appli-
ance will be damaged if operated while sitting on a surface or on its side.
CHOOSE A LOCATION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing location. As
this will become your most used kitchen appliance, it is recommended to mount the
CLEANCut™ close to your sink or food prep area.
• DO NOT mount over any heating or cooking appliance such as your range or oven.
• DO NOT mount under, in front of or behind any under-cabinet light xtures.
CAUTION: When selecting a location for your CLEANCut™, make sure you have
adequate room to reach the power jack. Be sure to unlatch the main body to ensure that
nothing hits the power jack.
CAUTION: There needs to be a minimum of 13-1/4” of space between the surface that the
CLEANCut™ is mounted to and the counter top.
DETERMINE CABINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine if your
cabinet has a at bottom
[
B
]
or an overhanging lip
[
C
]
. If your cabinet is at, follow STANDARD
INSTALLATION; if the cabinet has a lip, refer to SPACER MOUNTING INSTALLATION.
To Next Page
Loading...