[
J
]
10
LOADING INSTRUCTIONS
1. Pull opening latch to release the main body.
2. Push the main body down completely until it stops to ensure it is FULLY opened.
NOTE: Make sure pinch rollers are recessed to completely open the insertion slot
[
J
].
NOTE: The CLEANCut™ appliance is equipped with a security feature to prevent opera-
tion while the unit is opened.
3. Lift dowel rod to remove from device
and dispose of empty cardboard tube
from previous use (if any).
4. Insert the dowel rod through the center
of a new paper towel roll.
5. Once paper towel roll is loaded
onto the dowl rod, place into the dowel cradle.
NOTE: It is recommended that you place the roll into the cradle so that the paper comes
up from the bottom front of the roll
[
SEE ILLUSTRATION K
]
.
HOW TO USE
10. Once spacers are set (if necessary), hold CLEANCut™ and mounting bracket up and
tighten screws into mounting holes to secure.
NOTE: Always tighten screws to ensure the appliance does not move or shake during op-
eration. Be careful not to over-tighten the screws to avoid damaging the mounting bracket.
NOTE: If you wish to conceal the power cord, drill a 3/8” hole through the bottom of the
cabinet fl oor at the rear and to the side of the cabinet. Now the power cord connector can
be run down through the 3/8” hole and connected to the power jack. The power adapter can
be plugged into a standard electrical outlet available inside the cabinet. If this outlet is not
available then one can be installed by a quali ed electrician.
11. Plug power cord connector into the power jack in the back of the appliance. Plug into
standard electrical outlet. Extra cord should be hung over cord management hooks
behind unit
[
SEE ILLUSTRATION E
]
.
CAUTION: Make sure power cord does not fall into the roll.
12. Your CLEANCut™ appliance is now ready for use! For operating instructions, see the
HOW TO USE section of this manual.
To Next Page
Loading...