CleanMaster Raptor 220

Questions and Answers

D
deanbradyAug 6, 2025
What to do if CleanMaster Vacuum Cleaner has poor solution pick-up?
- I
  ivan62Aug 6, 2025
  If your CleanMaster Vacuum Cleaner isn't picking up solution well, there are several possible causes. First, ensure the recovery tank drain valve is closed. A defective recovery tank lid gasket can also cause this issue, so consider replacing it. Check for a clogged float shut-off screen by removing the recovery tank lid and cleaning the screen. Also, make sure the vacuum hose connections are secure. If the vacuum hose is defective, replace it.
D
douglas52Aug 12, 2025
What to do if CleanMaster Raptor 220 Vacuum Cleaner solution pump does not operate?
- Z
  zgarzaAug 12, 2025
  If the solution pump on your CleanMaster Vacuum Cleaner isn't working, make sure the trigger on the wand is pulled. Check that the quick couplers are fully engaged. If these steps don't resolve the issue, there may be a faulty switch, wiring, solution pump motor, or pump head, and you should contact the service center.
N
nicole01Aug 16, 2025
Why my CleanMaster Raptor 220 Vacuum Cleaner does not operate?
- R
  raymondgregoryAug 16, 2025
  If your CleanMaster Vacuum Cleaner isn't turning on, it could be due to a few reasons. Check if the building circuit breaker has tripped and reset it if necessary. If the breaker is fine, the issue may be with faulty switches, wiring, or the power cord, in which case you should contact the service center.
C
Charles BrownAug 21, 2025
How to fix uneven spray from CleanMaster Raptor 220?
- A
  Alexandria GriffinAug 22, 2025
  To fix uneven or no spray from your CleanMaster Vacuum Cleaner: * Check the solution tank level and refill if it's low or empty. * Inspect the spray tips for clogs and clean or replace them. * Ensure the spray tips are the correct size and angle, replacing them if needed. * Replace worn spray tips.
P
Patrick WebbAug 27, 2025
What to do if CleanMaster Vacuum Cleaner vacuum motor does not operate?
- A
  Alexandra CurtisAug 27, 2025
  If the vacuum motor on your CleanMaster Vacuum Cleaner isn't working, it could be due to loose or broken wiring, a faulty vacuum switch, a defective vacuum motor, or worn carbon brushes. In any of these cases, contact the service center.
B
Betty RochaAug 31, 2025
Why CleanMaster Raptor 220 heater does not heat?
- M
  Mary PetersAug 31, 2025
  If the heater in your CleanMaster Vacuum Cleaner isn't heating, it might be due to a faulty switch or wiring. Contact the service center.