21 EN
• Removing: Press the release button (2) on the side of the
handle (3) and pull out the cordless vacuum cleaner.
Charging station
• Assembling: Plug together the two parts of the charging
station (23) (see picture).
• Taking apart: Press the release button (20) at the bottom
on the back and pull both parts of the charging station (23)
apart at the same time.
• On the back of the charging station (23) there are holders
for storing the crevice and brush nozzle (19). Place the
crevice nozzle (18) in the top holder and the brush noz-
zle (19) in the bottom holder.
To pull out the brush nozzle (19), grip and pull the
bristles at the top end.
• Hook the frame (6) into the charging station (23).
Charging Up the Battery
PLEASE NOTE!
■ Switch off the device before you charge it.
• It is essential that you charge up the battery fully before you fi rst use
the device in order to achieve the maximum charging capacity.
• If the battery is fully discharged during use, it must be fully charged up again
before it is next used.
1. Place the assembled charging station (23) in a dry location near to a properly in-
stalled, easily accessible plug socket.
2. First plug the barrel connector on the mains cable into the socket (22) of the charging
station (23) and then connect the mains adapter (21) to the plug socket.
3. Hook the frame (6) into the charging station (23). The battery control lamps (9) will
fl ash during the charging process.
4. If all three battery control lamps (9) light up constantly, the battery is fully charged up.
To Next Page
Loading...
