2. Intended Use
This HALOONE
™
unit is intended for dry salt inhalation solely and strictly in accordance with this Manual
including (without limitation) only using HALOONE
™
salt capsules provided by the manufacturer. Users
must comply with this Manual and any supplemental installation, operation and maintenance instructions
provided by the manufacturer. Any other use of the HALOONE
™
is not considered in accordance with
these terms and the intended use. The manufacturer/supplier is not liable for any damage to persons
and/or property that may arise from improper use. The user alone incurs this risk.
The HALOONE
™
unit is designed to be used in a room up to 12’ x 12’ (3.5m x 3.5m). The HALOONE
™
can also be used inside a sauna up to a maximum temperature of 140°F (60°C) for no more than one
consecutive hour. The HALOONE
™
unit is not designed for continuous use in the sauna and should be
removed after each use if the sauna is used for multiple sessions in a day.
The HALOONE
™
unit will provide a fine salt mist in any room or sauna where it is operated. Care should
be taken to cover, seal and/or remove any electronic equipment or objects that could be affected by fine
salt particles. Please let common sense guide you when choosing which rooms to use the HALOONE
™
.
With normal use, the HALOONE
™
should not cause any problems to the room environment, but
manufacturer/supplier assumes no liability or responsibility for any claims or damages that may arise
except as expressly set forth in the HALOONE
™
warranty.
3. Safeguards
During a single session, the HALOONE
™
can distribute approximately 20ml of 3% saline in aerosol form.
Saline mist can have a corrosive effect on various materials such as metal, concrete and electronic
devices. Those items may be damaged as a result and should not remain near the HALOONE
™
while
in operation.
• The HALOONE
™
can be mounted to a wall or placed on a level and flat surface. When wall
mounting the unit, please make sure it is level.
• Only use saline cartridges provided by HALOONE
™
. Using other solutions may have adverse effects
on functionality and damage the device.
3