Need help?Do you have a question about the ClearOne CONNECT Dante and is the answer not in the manual?
Specifies the required software and firmware versions for compatibility.
Details the process for updating CONVERGE Pro firmware to version 4.3 or higher.
Explains how to assign a unique ID to each CONNECT Dante unit.
Describes how to physically connect the Dante units to the CONVERGE Pro/SR stack.
Provides instructions for configuring the CONNECT Dante using Dante Controller software.
Steps to upgrade firmware from older CONVERGE Pro versions.
Specifies the required software and firmware versions for compatibility.
Details the process for updating CONVERGE Pro firmware to version 4.3 or higher.
Explains how to assign a unique ID to each CONNECT Dante unit.
Describes how to physically connect the Dante units to the CONVERGE Pro/SR stack.
Provides instructions for configuring the CONNECT Dante using Dante Controller software.
Steps to upgrade firmware from older CONVERGE Pro versions.
General| Bit Depth | 24-bit |
|---|---|
| Network Interface | Gigabit Ethernet |
| Power over Ethernet (PoE) | No |
| Latency | 1 ms |
| Sample Rate | 48 kHz |
| Power Supply | 12V DC, 1A |
| Connectivity | Ethernet |
To Next Page