www.clearwellmobility.co.uk
4
Freewheeling the Scooter
Freewheeling the Scooter
When the vehcile is switched off the brakes are automatically engaged. This is called
failsafe braking. Also, if the batteries are at, the brakes are applied. There may be
occasions where you may wish to move the vehicle without power. To do this there is a
freewheel device tted.
The freewheel device allows the vehicle to be pushed without power. To activate, rst
locate the lever. When standing behind the scooter, it is located on the right hand side of
the rear of the vehicle.
• Make sure the ignition is turned off.
• Move the lever up. The vehicle can now be pushed in freewheel.
• Move the lever down to enage drive. The vehcile is now braked and at the normal
operating position.
WARNING: Never sit on the scooter when it is in freewheel mode and never put your
scooter in freewheel mode on any incline.
To Next Page
Loading...