@clearwellmobility @clearwellmob
7
Assembly
Connecting Front & Rear Sections
• Carefully align the pins so that they are positioned over the rear cups and press down
on the front chassis until it clicks into place.
• Check that the chasis release catch is in the locked position and the two halves are
securely together.
Ret the Battery Box
• Ensure it is correctly positioned and secure using the buttery catch.
Tiller
• Adjust the tiller into an upright position and release the tiller lock.
Attach Seat
• Lift the seat and install on the rear chassis, ensuring it is fully enaged and does not
rock or rotate.
• If you require more room in the width of the seat, the armrest width can be adjusted
by undoing the knobs on the underside of the armrests.
• To operate the swivel seat, pull the release lever up (located under the seat) and the
seat will release allowing it to rotate. Release the lever to lock.
Driving
• Adjust your seat and tiller to a comfortable driving position.
WARNING:
• Assembling the scooter involves lifting and handling heavy parts.
• Be careful to avoid being pinched or having your hands crushed when lifting or han-
dling parts.
• Never unload your scooter on sloping or uneven ground. It could run down the slope
and injure someone.
Assembly
NOTE: Ensure you have sufcient room when disassembling or assembling your
scooter to move the parts around. No tools are required to disassemble or assemble
your scooter.
To Next Page
Loading...