Cleco 48EA Series - Page 11

Page 11
PL12EN-48EA
08/06/2015
Cleco
®
Operation and Maintenance
Operation:
A reaction bar and bracket must always be used in high torque applications above 50 ft.-lbs. (68 Nm) or in close
quarter areas where entrapment and injury to hands or ngers could occur.
Maintenance:
Only qualied and trained personnel are to perform maintenance on these tools.
Regular maintenance reduces operating faults, repair costs and downtime. In addition to the following service
schedule, implement a safety related maintenance program that takes the local regulations for repair and
maintenance for all operating phases of the tool into account.
WARNING
Application
Spindle Rotation
Torque Reaction
Maintenance
Interval
Rundowns
Daily Daily
!
!
!
!
Visual inspection of all cables and connections
Visual inspection of the 48EA tool
Check the tool for excessive vibration or unusual noises
Visual inspection of all external components of the tool
Approximately 100,000
!
!
!
!
Inspect the tool cable for damage or wear
inspect the square drive output spindle for damage or wear
Inspect the tool cable connection for a secure fit
Check the maximum free speed
Approximately 500,000
!
!
!
!
Visual inspection of disassembled 48EA tool
Check individual parts for wear or damage and replace if necessary
Clean and lubricate angle head, gearing and motor bearings
Check and recalibrate transducer (48EA models)
Approximately 1,000,000
!
!
!
!
Visual inspection of disassembled 48EA tool
Check individual parts for wear or damage and replace if necessary
Clean and lubricate angle head, gearing and motor bearings
Check and recalibrate transducer (48EA models)
Designation