14
Step 9
Once the Rigid LATCH Connectors are
connected to the LATCH lower anchors,
check both LATCH Connector lock indicators
located behind the Rigid LATCH Connectors
to make sure they have changed from red
(unlocked) to mostly green (locked) as shown
in Figure 19.
Pull forward on this car seat to make sure it
is securely attached to the vehicle’s LATCH
lower anchors on both sides. If not, go back
to Step 8.
NOTE: It may be necessary to adjust the car
seat to recline position 1 in some vehicles in
order to connect Rigid LATCH Connectors to
the vehicle LATCH Lower Anchors. If Rigid
LATCH Connectors cannot be successfully
connected in this position, it may be
necessary to go back to step 2 and try a
different seating position.
IMPORTANT: If Rigid LATCH Connectors
fail to connect to the vehicle’s LATCH lower
anchors, you can still use this seat. See
“Installing Forward-Facing Car Seat With
Inflatable Vehicle Belt” on page 20 of this
manual. Please notify Clek Customer Service
if the Rigid LATCH Connectors fail to latch by
calling 1-866-656-2462.
Figure 19
To Next Page
Loading...
