16
Step 12
Check fit against the vehicle seat back. If the
back of this car seat cannot be adjusted to
be in contact with the vehicle seat back as
shown in Figure 23, try changing the recline
position of this car seat, verify that the
vehicle seat back is in a more upright
position and re-adjust.
If this seat cannot be positioned so that car
seat back is in contact with the vehicle seat
back, try a different LATCH equipped vehicle
seating position or install with a vehicle belt.
See “Installing Forward-Facing Car Seat
With Inflatable Vehicle Belt” on page 21 of
this manual.
A small gap between the top or bottom of the
car seat and vehicle seat back is acceptable
as long as there is contact with the front
surface of the vehicle seat back or headrest.
Figure 24 shows an unacceptable gap.
Figure 23
Figure 24
To Next Page
Loading...
