DC Manual
1. Read this entire manual and follow all installation and operating
instructions.
2. Always use a proper ground cable.
3. Always use a safety cable to attach the vibrator to an independent
stronghold. Do not operate the vibrator on an empty structure. This can
damage the structure or the vibrator.
4. If a truck battery is used to power the vibrator, the vehicle engine
should remain running while the vibrator is in use. Keep all ancillary
equipment such as air conditioners turned o while operating the
vibrator.
5. Do not operate the vibrator with the cover removed or if any fasteners
are missing.
6. Disconnect or lock out the electrical supply before performing
maintenance on the vibrator.
MOUNTING ON TRUCK BED
Mount each vibrator on an independent channel
iron. Locate the channel iron as close as possible to
the material ow problem area. The most common
Installation
• Vibrators have a ~5 ft. radius of inuence on material and structure
• Vibration transfers better through curves than through corners
• When in doubt where to place a vibrator, think about where your problem
point is and make sure vibration gets to it
To Next Page
Loading...