Clevo NJ70CU - Removing the M.2 SSD Module

Disassembly
Removing the M.2 SSD Module 2 - 15
2.Disassembly
Removing the M.2 SSD Module
1. Turn off the computer, turn it over to remove the keyboard (page 2 - 10) and battery (page 2 - 5).
2. The M.2 SSD module will be visible at point on the mainboard (Figure 9a).
3. Remove the screw
(Figure 9b)
4. The M.2 SSD module (Figure 9c) will pop-up, and you can remove it from the computer.
5. Reverse the process to install a new module (do not forget to replace all the screws and bottom cover).
1
2
3
b.
c.
a.
2
3
1
3

Thermal Pad
Be sure to place the thermal pad’s adhesive side down onto the
mainboard surface.

3.M.2 SATA Module
•1 Screw
Figure 9
M.2 SSD Module
Removal
a. Locate the M.2 SSD.
b. Remove the screw.
c. The M.2 SSD module
will pop up.