Clevo P650SE - Page 33

Disassembly
Removing the Hard Disk Drive 2 - 9
2.Disassembly
4. Slightly lift and pull the hard disk in the direction of arrow (Figure 5c).
5. Lift the hard disk assembly out of the bay (Figure 5d).
6. Remove screws - and bracket from the hard disk (Figure 5e).
7. Reverse the process to install a new hard disk (do not forget to replace the screws).
6
7
8
9
16
17
18
c.
9
7
6
e.
d.
8
10
17
13
14
16
15
11
18
18

Installing 9.5mm or 7mm HDD
Note that the hard disks pictured on the following pages are all
7mm(h) hard disk drive.
In some cases 9.5mm(h) hard disk drives will be installed. It can be
installed on either upper or lower slot.
There are two hard disk drive options:
Two changeable 2.5" (6cm) 7.0mm (h) SATA (Serial) Hard Disk
Drives/Solid State Drives (SSD) supporting RAID level 0/1
Or
One changeable 2.5" (6cm) 9.5mm (h) SATA (Serial) Hard Disk
Drive/Solid State Drive (SSD)
For more information, contact your distributor/supplier, and bear in
mind your warranty terms.
12

7. HDD Assembly
17. Adhesive Cover
18. HDD
•8 Screws
Figure 5
HDD Assembly
Removal (cont’d.)
c. Slightly lift and pull the
HDD in the direction of
the arrow.
d. Lift the HDD assembly
out of the bay.
e. Remove the screws and
bracket from the HDD.