Clevo P650SE - Removing the System Memory (RAM)

Disassembly
2 - 10 Removing the System Memory (RAM)
2.Disassembly
Removing the System Memory (RAM)
Figure 6
RAM-1 Module
Removal
a. The RAM modules will
be visible at point .
b. Remove the screws
and lift the shielding
plate out.

Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module’s
performance.
1
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDR3L Up to 1600 MHz. The main memory can be expanded up to 32GB. The SO-DIMM modules supported are
1024MB and 2048MB DDR3L Modules. The total memory size is automatically detected by the POST routine once you
turn on your computer.
Memory-1 Upgrade Process
1. Turn off the computer, turn it over, remove the keyboard (page 2 - 5).
2. The RAM modules will be visible at point after removing the shielding plate (Figure 6a
).
3. Remove screws
- and lift the shielding plate off the computer (Figure 6b).
1
2
5
6
a.
1
6
2
3
5
4
b.

6. RAM Shielding Plate
•4 Screws