Clevo P775DM3 - Page 30

Disassembly
Removing the M.2 SATA Module 2 - 21
2.Disassembly
M.2 SATA Installation Procedure
1. Place the thermal pad on the computer as shown (
Figure 16a).
2. Insert the module in the computer. Make sure that the hexagonal screw is in the correct location (
Figure
16b
).
3. Tighten the screw to secure it in place (
Figure 16c).
1
Figure 16
M.2 SATA Module
Installation
a. Place the thermal pad.
b. Insert the module.
c. Tighten the screw.
2
3
4
a.
4
2
b.
1
c.
3

Thermal Pad
Make sure you place the thermal pad’s adhe-
sive side down onto the computer surface as
illustrated.
The usage of the thermal pad will depend
upon the thickness of the module being used.
• If you are using the thinner module, then
apply the whole thermal pad provided on
the computer.
• If you are using the thicker module, sepa-
rate the pad into its two parts. Use the
larger part and place the adhesive side
onto the computer (discard the smaller
part that you have separated).

1. Thermal Pad
2. M.2 SATA Module
•1 Screw